OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0402

Rear Drive Clutch Solenoid Valve

Publicly available J2012 tables skip C0402, yet GM assigns it in its rear differential clutch control module: the 2010–11 Saab 9-5 and the 2011 9-4X call it Transfer Case Solenoid Valve and describe the rear drive clutch solenoid, which the module drives by PWM to set the clutch pressure and so the torque sent rearward; the 2008–12 Saab 9-3 XWD calls it Differential Clutch Solenoid Valve. No maker documents it as a traction control lamp circuit. Subcode 02 is a short with coil resistance below 2 Ω, 04 an open with current off target by over 200 mA for 100 ms, 42/43/4B missing or bad calibration, 61 a valve that does not engage. AWD is switched off and Service Rear Axle appears; valve and module are replaced as a matched pair.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number4 / 02

Possible causes

  • Open or shorted solenoid valve circuit at the rear drive unit high
  • Valve calibration not stored after module replacement medium
  • Solenoid valve sticking because of contaminated or aged clutch fluid medium
  • Corroded connector on the rear axle module low

Symptoms

  • Service Rear Axle or AWD warning displayed
  • Car drives on the front wheels only

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0402

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication