C0376
Front Axle Disconnect
C0376 is not in the published J2012 lists. The number exists at GM, whose bulletin PIP5094 lists it next to transfer case codes such as C0374 and C0387, but no reachable GM document states what it means. The title part decouples the front axle so the front driveline stands still in two-wheel drive. GM handles the front axle actuator of 2007–13 Silverado, Sierra, Tahoe and Yukon under C0379 and blames moisture at the actuator plug. FCA stores such faults as C1463 or C147B: on the 2018 Wrangler the drivetrain module sets C147B-14 when the lock signal of the disconnect stays under 1.19 V for over 500 ms and then leaves the actuator where it is; for Ram 3500/4500 it advises checking the harness 6–8 inches from the plug. If the disconnect fails, 4WD may not engage or release.
Possible causes
- Water or corrosion in the axle actuator connector high
- Chafed actuator harness near the axle medium
- Disconnect actuator or its position switch defective medium
Symptoms
- Service 4WD message or flashing 4WD indicator
- Front wheels not driven although 4WD is selected
- Grinding or clicking from the front axle when shifting
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0376
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.