OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0374

4WD Drive Coupling

No publicly available J2012 list carries C0374; GM uses it in the transfer case control module of its 4WD trucks and SUVs, and PIP5094 names it among GM chassis codes. Dorman's sheets for the S10, Blazer, Astro and Safari, the Trailblazer, Envoy and Isuzu Ascender call it General 4WD Failure: in Auto 4WD the module notices rear wheel slip, commands torque to the front axle and still sees the front and rear propshafts turning at different speeds. After ten attempts that fail to couple the front drive it stores the code. Auto 4WD is then unavailable and Service 4WD stays lit until the next engine start. The fault thus points to the coupling path as a whole, encoder motor, clutch and speed sensors, rather than one circuit.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number3 / 74

Possible causes

  • Encoder motor too weak or sticking, so the clutch is not applied high
  • Front or rear propshaft speed sensor or its wiring giving false values medium
  • Worn transfer case clutch pack or wrong fluid medium
  • Tires of unequal size or pressure faking a speed difference low

Symptoms

  • Service 4WD message until the next engine start
  • Auto 4WD does not engage, rear wheels spin on slippery ground

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0374

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication