C0312
Ride Height Sensor Rear Right
Searches for C0312 in reachable J2012 lists, in GM sources and in the NHTSA bulletin index returned nothing, so only the component is described here. A ride height sensor at the right rear converts the swing of a lever arm linked to the suspension into an electrical signal, usually by inductive or Hall measurement, and feeds air suspension, damping or headlamp levelling. HELLA lists bent lever arms, broken wires, corroded plugs and water ingress as the usual failures. Makers use their own numbers here: RAM stores a stuck right rear height sensor on the 2022–23 1500 as C152A-2A and fixed it with module software, and BMW had to inspect rear sensor control rods on 2019 X5 and X7 models.
Possible causes
- Bent, detached or wrongly clipped sensor lever or link rod high
- Corroded connector or broken wire at the rear right sensor medium
- Sensor failed internally after water ingress medium
Symptoms
- Air suspension or levelling warning message
- Rear right corner sits too high or too low
- Headlamp levelling incorrect
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0312
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.