C0310
Transfer Case Motor A/B Circuit Open
C0310 is not listed in any publicly available J2012 table; no maker uses it for a rear left ride height sensor. GM assigns the number to the transfer case shift motor: it is in PIP5094, AA1Car gives the GM wording Motor A/B Circuit Open, and Dorman describes it for GM trucks and SUVs of 1998 to 2005. The transfer case module drives the motor through two lines, one switched to supply and the other to ground depending on direction. When it commands a low level on a line and reads a high voltage back instead, it concludes that line A, line B or the motor winding is open and stores C0310. Shifting is then blocked and Service 4WD lights up. A broken motor pigtail or connector is the usual cause.
Possible causes
- Broken motor control wire or pigtail exposed under the vehicle high
- Corroded or unseated connector at the shift motor medium
- Open winding or worn brushes in the shift motor medium
Symptoms
- Service 4WD lamp on, 4WD switch lights flash
- Transfer case stays in its last range
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0310
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.