C0300
Inlet Valve Front Left Performance
C0300 appears in none of the published J2012 lists, and no maker documents it as an ABS valve code. GM uses the number: it is among the chassis keywords of PIP5094, and AA1Car's GM table calls it Rear Speed Sensor Malfunction, listed in the same block as the transfer case motor codes C0306 to C0315. The title describes the front left inlet valve of the ABS valve block. That valve is open at rest and closes during a regulation cycle to hold pressure at the wheel; TRW, in the 2011 Saab 9-5, calls it the isolation valve. Saab's older 9-5 pulses every valve for 20 ms at each ignition-on and, on a fault, switches off ABS, traction and stability control with their warning lamps. A sluggish front left inlet valve leaves that wheel under- or overbraked during ABS.
Possible causes
- Inlet valve sticking from contaminated or aged brake fluid medium
- Valve coil or driver in the brake module faulty medium
- On GM 4WD trucks, rear speed sensor fault in the transfer case system (GM meaning of the number) low
Symptoms
- ABS and stability control warning lamps on
- Car pulls during hard braking
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0300
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.