C0288
Yaw Rate Sensor Range
No reachable J2012 list carries C0288, and no known maker files a yaw rate range fault under it. GM's PIP5094 contains the number, and AA1Car's GM brake table gives it a quite different meaning: Brake Warning Lamp Circuit Shorted to B+. The title describes a yaw rate signal that leaves its permitted span. Where GM documents that case, it uses C019B instead: on the 2011 Saab 9-5 the brake module flags a yaw signal out of its specified range and then turns ESP and the hill start aid off until the next ignition cycle. The older Saab 9-5 sensor covers about ±138 degrees per second, reads zero at rest and is checked every 20 ms. Bosch explains the micromechanical Coriolis measurement used in such sensors.
Possible causes
- Sensor bracket loose, bent or sensor mounted crooked after body repair medium
- Yaw rate sensor drifting internally medium
- Unstable supply or ground at the sensor low
Symptoms
- Stability and traction control warning lamp on
- Stability control disabled for the rest of the trip
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0288
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- static.nhtsa.gov/odi/tsbs/2013/MC-10112857-9999.pdf
- aa1car.com/library/abscodes.htm
- saabwisonline.com/9-5-9650/2011/5-brakes/tcs-esp/fault-diagnosis-diagnostic-trouble-codes/dtc-c0187-c0196-c019b-c0287-or-c0297
- saabwisonline.com/9-5-9600/2004/5-brakes/stabiliser-system-esp/technical-description/yaw-rate-sensor-lateral-acceleration-sensor
- bosch-mobility.com/en/solutions/sensors/inertial-measurement-unit/