C0279
Brake Booster Boost Sensor Circuit Malfunction
C0279 is absent from every publicly available J2012 list, and no maker describes it as a booster sensor code. GM does use the number: its bulletin PIP5094 names it among the chassis keywords for 2014 and older cars and light trucks, and the GM brake code chart published by AA1Car renders it as Powertrain Configuration Not Valid, meaning the brake module received engine or driveline data it was not set up for. The part in the title reports how much vacuum or boost pressure the brake booster holds. On the 2011 Saab 9-4X the brake module feeds such a sensor with 5 V and switches an electric vacuum pump on when the reading drops; Bosch uses the same signal for start/stop and brake assist. With the circuit faulty, the module loses that reading.
Possible causes
- Open or shorted 5 V supply, signal or ground wire of the booster sensor medium
- Booster pressure sensor failed or its grommet leaking medium
- Brake module not configured for the fitted engine or driveline (GM meaning of the number) low
Symptoms
- Brake or ABS warning lamp on
- Electric vacuum pump runs constantly or not at all
- Start/stop or brake assist unavailable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0279
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.