C0240
Brake Pressure Sensor
C0240 cannot be verified publicly: it is missing from the accessible J2012 lists, from the NHTSA bulletin index, from GM's PIP5094 keyword list and from the Saab and Mitsubishi indexes. Only the part in the title can be described. In a modern brake control unit a pressure sensor reports how hard the driver presses; on the TRW EBC450 of the 2011 Saab 9-5 it is built into the valve block. The module feeds it 5 V and expects about 0 V with the pedal released and more than 1 V when braking. A broken supply or signal line, or a reading that does not fit the deceleration or brake switch, disables ABS, traction and stability control; GM files that fault under C0131. Brake assist and stability control use this signal to judge braking demand.
Possible causes
- Open or shorted 5 V supply or signal wire to the pressure sensor medium
- Faulty pressure sensor inside the hydraulic unit medium
- Sensor offset not calibrated after module or valve block replacement low
Symptoms
- ABS, traction and stability warning lamps on
- Brake assist and stability control unavailable
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0240
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.