C0230
Brake Pedal Position Sensor Circuit
C0230 is in none of the accessible J2012 tables and in no NHTSA bulletin or manufacturer index, so it cannot be traced to a vehicle. The title points to the electrical side of a brake pedal position sensor: a supply, signal or ground line that is open or shorted, so the reading falls outside the band the module accepts. GM's patent for a two-output resistive sensor names these out-of-range low and high conditions as the standard on-board check before it adds a test for faults within the range. Bosch's Hall-type PWG sensor delivers two independent PWM outputs; if one disappears or both disagree, the controller can tell a wiring fault from a real pedal movement. Expected effects are stop lamp or cruise control trouble, a lit warning lamp and, on hybrids, limited brake blending.
Possible causes
- Open or shorted supply, signal or ground wire of the sensor high
- Corroded or loose connector at the pedal sensor medium
- Internal sensor fault (worn track, failed Hall element) medium
Symptoms
- Brake or stability warning lamp on
- Stop lamps or cruise control behave incorrectly
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0230
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.