OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C00A5

Driveline Control Module Transfer Case Unit Control Circuit Driver

C00A5 concerns the output stage in the driveline module that powers the transfer case actuator, typically a DC gearmotor that shifts range and mode or presses a multi-plate clutch. Bosch describes such a transfer case clutch driven by a DC motor with worm gear through an H-bridge, with motor speed, worm wheel position and motor current measured; Magna's shift patent regulates the gearmotor speed by PWM and switches to closed-loop position control near the end of travel. The code is set when the module sees a fault at its own driver, such as overcurrent, a short to ground or battery, an open load or thermal shutdown, the categories listed for H-bridge ICs like TI's DRV8873-Q1. The actuator itself is covered by C00A6. No manufacturer publishes a C00A5 case. The transfer case then usually holds its last state or drops to 2WD.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / A5

Possible causes

  • Shorted transfer case motor wiring or connector high
  • Binding or worn transfer case motor causing overcurrent medium
  • Defective H-bridge in the driveline module low

Symptoms

  • 4WD/AWD cannot be engaged or range shift refused
  • 4WD service warning in the cluster

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C00A5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication