OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C00A4

Driveline Control Module Rear Differential Unit B Control Circuit Driver

Where a rear unit carries a second actuator, for example the second clutch of a twin-clutch module that can drive each rear wheel on its own, the driveline module needs a second output stage, and C00A4 reports a fault in that one. If actuator B is a brushless motor, the stage is a three-phase bridge: automotive gate drivers such as TI's DRV8343-Q1 detect short to battery, short to ground, MOSFET overcurrent and gate driver faults, and offer an offline open-load and short check before the motor is switched on. BorgWarner's latest AWD coupling uses exactly such a brushless motor with integrated electronics. A driver fault on side B leaves actuator A usable, so some systems can keep partial AWD. No manufacturer publishes a C00A4 case; the actuator's own codes are C0097 and C0098.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / A4

Possible causes

  • Phase or supply line of actuator B shorted to ground or battery high
  • Winding fault or blocked rotor in actuator B causing overcurrent medium
  • Failed output stage B in the module low

Symptoms

  • AWD or torque vectoring warning
  • One rear clutch or locking function inactive

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C00A4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication