C00A3
Driveline Control Module Rear Differential Unit A Control Circuit Driver
C00A3 points to the driver stage inside the driveline module that powers actuator A of the rear differential unit, not to the actuator itself. The module's own transistor monitoring reports something wrong at that output. A Mitsubishi Electric patent illustrates the principle on an electromagnetic clutch: a PWM high-side and a low-side transistor feed the coil, the filtered terminal voltages are checked with the selector in P or N, and if they deviate from normal both transistors are switched off so the clutch opens. Modern H-bridge drivers such as TI's DRV8873-Q1 separately flag overcurrent, short to battery or ground, open load and overtemperature. On hydraulically actuated twin-clutch units, a dedicated ECU drives solenoid valves instead. No manufacturer publishes a C00A3 case; actuator A's own codes are C0095 and C0096.
Possible causes
- Short to ground or battery in the actuator A supply lines high
- Actuator A motor or coil drawing excessive current (binding, winding short) medium
- Output stage in the module overheated or defective low
Symptoms
- Rear clutch released, AWD inactive
- AWD warning in the instrument cluster
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C00A3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.