C00A2
Driveline Control Module Power Transfer Unit Control Circuit Driver
The power transfer unit sits at the front transaxle of a front-based AWD car and, on disconnecting systems, can uncouple the propshaft. AAM's EcoTrac, introduced on the 2014 Jeep Cherokee, separates the driveline at both the PTU and the rear module under command of its own control unit. In an AAM patent a power-operated actuator, for example a solenoid, moves the PTU mode collar only after the rear clutch has brought the propshaft up to speed; a Linamar patent energises a PTU coil with brief pulses of about 3 to 4 A and tracks the sleeve with a Hall or linear sensor. C00A2 means the output stage feeding that actuator reports a fault, such as overcurrent, short, open load or overtemperature, the classes that automotive driver ICs like TI's DRV8873-Q1 flag. No manufacturer publishes a C00A2 case.
Possible causes
- Short to ground or battery on the PTU actuator circuit high
- PTU actuator coil or motor open or internally shorted medium
- Damaged output stage inside the driveline module low
Symptoms
- AWD unavailable, vehicle stays in front-wheel drive
- AWD warning lamp or message
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C00A2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.