OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C00A1

Driveline Control Module

This umbrella code concerns the driveline control module itself, often called AWD or 4WD module, not one of its outputs or sensors. It covers internal faults such as memory or processor errors, a missing or poor supply and ground, or software and configuration problems that stop the module from controlling clutches, transfer case or disconnects. GKN describes such controllers as layered software, from operating system through actuator drivers up to vehicle functions; BorgWarner builds the electronics straight into the brushless actuator of its coupling. Ford gives a code-specific example: SSM 51659 covers 2023 F-Super Duty trucks built up to 9 May 2023 that store C00A1 in their AWD module or lose four-wheel drive, and asks to check that ground G239, under the right-hand front sill trim close to the BCM, is tightened to 8 Nm.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / A1

Possible causes

  • Loose or corroded module ground (Ford G239 on 2023 Super Duty) high
  • Low battery voltage or poor supply to the module medium
  • Module software or configuration fault, update or reprogramming needed medium
  • Internal failure of the driveline control module low

Symptoms

  • Four-wheel drive inoperative
  • 4WD/AWD warning or service message
  • Further driveline codes or lost communication with the module

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C00A1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication