OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C00A0

4WD/AWD Rear Differential Unit Actuator B Position Sensor Correlation

C00A0 is the plausibility check across all three position channels of actuator B. Each line may be intact, but the pattern they form is impossible, out of sequence or contradicts the commanded movement, so the controller can no longer trust where the second actuator stands. Woodward lists 000 and 111 as illegal states for 120-degree spacing and 101 or 010 for 60-degree spacing. A Hyundai Kefico patent uses all-zero and all-one readings to tell an open line from a short. Common roots are a shared ground or supply problem, a connector that is not latched, or a magnet that has shifted. Ford reports the sister code C009C for actuator A on the Bronco Sport, but no manufacturer publishes a C00A0 case. GKN notes that its actuator controllers include self-diagnostics.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / A0

Possible causes

  • Shared sensor ground or supply of actuator B faulty high
  • Actuator B connector not fully latched medium
  • Rotor magnet or sensor carrier shifted inside actuator B low

Symptoms

  • AWD fault message with rear torque control switched off
  • Possible loss of related assist functions shown in the cluster

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C00A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication