OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C009E

4WD/AWD Rear Differential Unit Actuator B Position Sensor B

Middle channel B of the second rear-unit actuator is reported here. It belongs to designs with two independently controlled elements; GKN's Twinster, used on the Focus RS rear drive module, can send torque to either rear wheel separately through two wet clutches. A fault in channel B of actuator B is typically an interrupted, grounded or frozen signal while channels A and C still switch. The detection logic in a Hyundai Kefico patent fits this case: it takes a healthy channel as reference, and a partner that never changes while the reference toggles is stored as defective. That patent also lets the motor run on in an emergency mode from the remaining edges. No public manufacturer document names C009E. The usual result is that the controller stops using the affected side and shows an AWD warning.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / 9E

Possible causes

  • Channel B signal of actuator B interrupted or grounded high
  • Harness chafed near the rear axle or exhaust heat shield medium
  • Internal sensor failure in actuator B medium

Symptoms

  • AWD fault message, one rear wheel no longer driven actively
  • Drift or sport drive modes unavailable

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C009E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication