OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C009D

4WD/AWD Rear Differential Unit Actuator B Position Sensor A

Actuator B exists only on rear units with a second controlled element, for instance twin-clutch modules that apply torque to each rear wheel on its own, or a rear axle with an extra disconnect. GKN describes a separate actuator controller managing such twin-clutch actuation, adapting to clutch temperature and wear. C009D flags the first of the three position channels of this second actuator: its signal is absent, stuck or outside the permitted range. The sensing principle is the same as for actuator A, a set of Hall elements reading a rotor magnet, as Schaeffler's actuator patent and TI's commutation note show. No carmaker has published a C009D case. Because only one side or one function is affected, the module often shuts down left-right torque control first, then AWD altogether.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / 9D

Possible causes

  • Wiring fault on channel A of actuator B high
  • Poor contact in the actuator B connector medium
  • Hall element A in actuator B failed medium

Symptoms

  • AWD warning, torque vectoring or locking function unavailable
  • Vehicle may push wide in corners where it normally rotates

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C009D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication