OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C009C

4WD/AWD Rear Differential Unit Actuator A Position Sensor Correlation

Each of the three position channels of actuator A may look electrically fine, yet together they make no sense: a combination that cannot occur, a sequence that skips states or runs against the commanded direction. With 120-degree spacing the patterns 000 and 111 are invalid, as a Woodward patent notes. Ford is the only maker with a public case: SSM 50188 reports C009C in the AWD module of 2021 Bronco Sport vehicles alongside cluster messages: Service AdvanceTrac, unavailable Hill Start Assist or Pre-Collision Assist, a 4WD Malfunction notice and Reduced Power. Ford blames connector C413 being only partly engaged or having loose terminals, which should be ruled out before a new rear drive unit is fitted; otherwise the workshop manual section 307-07A applies. Hyundai Kefico separates open from shorted lines via all-low or all-high readings.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / 9C

Possible causes

  • Rear drive unit connector not fully seated or loose pins (Ford C413) high
  • Poor shared sensor ground or supply corrupting all three channels medium
  • Internal sensor or magnet fault in the rear drive unit motor medium

Symptoms

  • 4WD Malfunction message and AWD switched off
  • Service AdvanceTrac, hill start assist or pre-collision assist unavailable (Ford)
  • Reduced Power message

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C009C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication