OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C009A

4WD/AWD Rear Differential Unit Actuator A Position Sensor B

Channel B is the second of the three position signals that actuator A of the rear differential unit reports to its control module. This code points at that one line or element, while channels A and C still deliver plausible edges. A Hyundai Kefico patent explains how a controller singles out such a channel: while one healthy Hall signal keeps toggling, a channel that never changes is marked faulty and a code is stored; all three reading low hints at an open supply, all three high at a short. The same document lets the motor continue in an emergency mode by estimating rotor angle from the remaining edges. BorgWarner equips its electro-hydraulic AWD coupling with a brushless actuator whose control electronics are built in. A public C009A case from a carmaker was not found. Expect an AWD warning and a released rear clutch.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number– / 9A

Possible causes

  • Damaged or chafed signal wire of channel B high
  • Loose or spread terminal for channel B in the actuator connector medium
  • Hall element B in the actuator motor defective medium

Symptoms

  • AWD warning with the vehicle driving on the front axle only
  • Fault may come and go with temperature or vibration

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C009A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication