C0099
4WD/AWD Rear Differential Unit Actuator A Position Sensor A
The title gives actuator A of the rear differential unit three position channels, A to C. That layout matches the way brushless actuator motors track their rotor: three Hall elements on the stator read a magnet on the rotor, and their combined states step the motor through six commutation phases. C0099 concerns channel A alone. It is logged when that signal drops out, sticks or leaves its voltage window, typically from an open wire, a short to ground or a dead Hall element. Schaeffler patents a sensor carrier of this kind for a clutch actuator motor, TI documents Hall-based commutation, and BorgWarner drives its current AWD coupling with a brushless motor. No manufacturer publishes a C0099 case. Losing one channel usually means the rear clutch is released and an AWD warning appears.
Possible causes
- Open or grounded signal wire of channel A between actuator and module high
- Corroded or loose connector at the rear drive unit medium
- Failed Hall element A inside the actuator motor medium
- Missing sensor supply or ground from the module low
Symptoms
- AWD/4WD warning lamp or message in the cluster
- Rear axle no longer driven, front-wheel drive only
- Reduced traction on slippery surfaces
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0099
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.