C0081
ABS Malfunction Indicator
Covers the ABS malfunction indicator (warning lamp) itself as driven or monitored by the ABS/ESC module. The module commands the ABS lamp on for a fault and off when healthy, and monitors the output circuit; this code is set when the lamp circuit is open or shorted, the lamp does not respond, or the commanded and observed states disagree, for example a bulb-check failure or a bus message not reaching the cluster. It is about the indicator path rather than the ABS hydraulics, so braking and ABS themselves may still work while the driver loses the warning. The related rear-axle mismatch and wheel-speed codes describe the faults the lamp would normally announce. No code-specific public bulletin was confirmed; the entry follows the SAE J2012 generic definition and warning-lamp output monitoring.
Possible causes
- Open or shorted indicator circuit high
- Lamp request not reaching the cluster medium
- Failed indicator bulb or driver low
Symptoms
- ABS warning lamp stuck on or off
- Failed lamp self-check
- Driver loses ABS warning
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0081
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.