C0072
Brake Temperature Too High
Set when the brake or stability module estimates that brake temperature has risen above a safe threshold. Few vehicles measure rotor temperature directly; most run a thermal model that integrates braking force, speed and time to estimate how hot the brakes are, and warn or adapt control when overheating is likely, for example on a long descent. The code is stored when the modelled or measured temperature exceeds the limit, prompting a driver warning and sometimes reduced regenerative blending or electronic brake-force changes. It is advisory and protective rather than a wiring fault; braking and ABS continue. Persistent setting can indicate a dragging brake or an implausible model input. The entry follows the SAE J2012 generic definition and electronic brake-system thermal modelling.
Possible causes
- Brakes overheated on a long descent high
- Dragging brake or stuck caliper medium
- Implausible input to the thermal model low
Symptoms
- Brake temperature warning to driver
- Reduced regenerative braking blend
- Brake fade on long descents
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0072
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.