C0071
2/4 Wheel Drive Status Input
Covers the input that tells the ABS/ESC module whether the vehicle is in two- or four-wheel-drive mode. Because four-wheel drive links the axles and changes how wheel speeds relate, the stability and ABS strategy must know the current drive mode; this signal comes from the transfer-case switch, the drive-mode selector or a message from the drivetrain controller. The code is set when that status is missing, implausible or inconsistent with observed wheel behaviour. Subaru documents DTC C0071 in the vehicle dynamics control system with revised troubleshooting. A fault can make the module default to a safe strategy, disable some functions and set the ABS/ESC warning lamp while base braking remains. The entry follows the SAE J2012 generic definition and all-wheel-drive mode-signalling design.
Possible causes
- Transfer-case or mode switch fault high
- Missing drive-mode message on the bus medium
- Harness or connector fault low
Symptoms
- Stability or ABS strategy limited
- ABS/ESC warning lamp on
- Drive-mode display incorrect
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0071
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.