C004E
Brake System Pressure Control Valve Actuator Stuck
Set when the actuator of a brake system pressure control valve does not move as commanded and appears mechanically stuck. In electronically controlled brake and stability systems a pressure control valve regulates how much hydraulic pressure reaches the wheel circuits; the module commands the valve and checks the resulting pressure against the demand. When the pressure does not change although the valve was commanded, or the valve position feedback does not follow, the module concludes the actuator is stuck by contamination, corrosion or a mechanical fault. Pressure modulation for ABS, traction and stability is lost on the affected circuit and the brake or ABS warning lamp is set while base braking remains.
Possible causes
- Valve actuator stuck by contamination or wear high
- Corrosion or debris in the valve bore medium
- Valve driver or wiring fault low
Symptoms
- ABS, traction and stability control disabled
- Abnormal brake behaviour on one circuit
- ABS or brake warning lamp on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C004E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.