C004D
Brake System Pressure Slow Response
A performance code set when the brake system builds or changes hydraulic pressure more slowly than the control unit commands during an assisted or automated braking event. In electronically controlled brake systems the module commands a target pressure and watches the pressure sensor; if the measured pressure lags the demand beyond a calibrated time or rate it concludes the pump, motor, valves or hydraulic path cannot respond quickly enough. It is a plausibility and timing fault rather than a single electrical defect, and can be caused by air in the system, a weak pump, a sticking valve or a restriction. Automated braking and stability functions are limited and the brake or ABS warning lamp is set. The entry follows the SAE J2012 generic definition and electro-hydraulic brake control design.
Possible causes
- Air in the hydraulic system or low fluid high
- Weak pump or motor performance medium
- Sticking valve or hydraulic restriction low
Symptoms
- Longer pedal travel or delayed assist
- Automated braking functions limited
- ABS or brake warning lamp on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C004D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.