C004A
Brake Lining Wear Sensor
Covers the brake lining (pad) wear sensor circuit, which warns the driver when friction material is worn to its limit. Electronic wear sensors use a loop embedded in the pad that the disc contacts and opens, or a wear-indicator circuit, as the lining wears down; the module reports pad wear and may store this code for an open, shorted or implausible sensor circuit as well as for a genuine worn-pad signal. It is an advisory function rather than a safety-critical control loss: braking and ABS continue, but the driver is told to inspect or replace the pads. The code can appear after pad replacement if the sensor was not renewed or reconnected. Delphi describes both the single loop and two-stage sensors with two resistor circuits. No manufacturer documents this code publicly.
Possible causes
- Brake pads worn to the sensor limit high
- Open or shorted wear sensor circuit medium
- Sensor not renewed after pad change low
Symptoms
- Brake pad wear warning message
- Warning lamp on
- Possible squeal from a mechanical indicator
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for C004A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.