C0045
Brake Pressure Sensor B
C0045 covers brake pressure sensor B, the second pressure transducer in the ABS/ESC hydraulic unit next to sensor A (C0044). Two sensors let the module watch both brake circuits or check one reading against the other for stability control, brake assist and brake-by-wire functions. The code sets for a signal out of range, an open or short, or a value that disagrees with sensor A or the pedal demand. Where the sensor sits inside an integrated brake unit, repair usually means replacing the whole unit. NHTSA's EPS safety report lists C0045 with this J2012 meaning. Older GM vehicles use C0045 for the left rear wheel speed sensor circuit instead (GM PIE0456, 16-NA-248), so the make decides what a stored C0045 means.
Possible causes
- Pressure sensor failed or out of range high
- Fault internal to the integrated brake unit medium
- Signal does not correlate with sensor A low
Symptoms
- ABS or brake warning lamp on
- Stability and assist functions disabled
- Changed brake assist behaviour
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0045
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.