C0044
Brake Pressure Sensor A
Covers brake pressure sensor A (sensor 1) in the ABS/ESC hydraulic unit, which measures master-cylinder or circuit brake pressure. The stability and brake modules use this reading to know how hard the driver is braking and to control traction, stability, brake assist and hill-hold. The module sets the code for a signal outside the valid range, an open or short, or a value that disagrees with pedal demand or a second pressure sensor. RAM assigns code C0044-01 to a general electrical failure of brake pressure sensor 1 on the 2024 2500; because the transducer sits inside the hydraulic control unit, the published repair replaces the whole integrated brake unit. A fault disables stability and assist functions and sets the ABS or brake warning lamp.
Possible causes
- Pressure sensor failed or out of range high
- Fault internal to the integrated brake unit medium
- Harness or connector fault low
Symptoms
- ABS or brake warning lamp on
- Stability and assist functions disabled
- Changed brake assist behaviour
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0044
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.