C003E
Rear Wheel Speed Sensor Supply
Covers the supply circuit that powers a single rear active wheel speed sensor on vehicles with one combined rear speed signal. Active sensors need a regulated voltage from the ABS/ESC module; this code is set when that supply is open, shorted to ground or another voltage, or outside the regulated range so the sensor cannot produce a valid signal. It is distinct from the sensor-signal code C003D in that the fault is on the feed rather than the sensor element. A fault disables ABS, traction and stability control and lights the ABS warning lamp while base braking remains. No manufacturer documents this code publicly; the J2012 table in NHTSA's EPS safety report lists C003E as the rear sensor supply.
Possible causes
- Open or shorted sensor supply wire high
- Corroded connector on the supply side medium
- Module sensor supply output fault low
Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- No rear wheel speed signal
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C003E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.