C001C
Right Rear Inlet Control
Covers the right rear inlet (apply) solenoid valve of the ABS hydraulic modulator, the right rear counterpart of C0010 and C0018. The module closes this valve to isolate the right rear brake circuit and hold wheel pressure during ABS, traction or stability control, then opens it to reapply pressure; on the rear axle the same channel often supports electronic brake-force distribution. It monitors the coil for opens, shorts to supply or ground and resistance outside the calibrated range. A confirmed electrical fault disables ABS and stability control and lights the ABS warning lamp while base braking remains. No manufacturer documents this code publicly; the apply valve per wheel is described by NHTSA and in a pump patent.
Possible causes
- Inlet valve coil open or shorted high
- Harness or connector corrosion medium
- Internal hydraulic modulator fault low
Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- Normal braking retained
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C001C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.