C0018
Left Rear Inlet Control
Covers the left rear inlet (apply) solenoid valve of the ABS hydraulic modulator, the rear-axle counterpart of C0010. The module closes this valve to isolate the left rear brake circuit and hold wheel pressure during ABS, traction or stability control, then opens it to reapply pressure. On many vehicles the rear channel also carries electronic brake-force distribution. The module monitors the coil for opens, shorts to supply or ground and resistance outside the calibrated range. A confirmed electrical fault disables ABS and the stability functions and lights the ABS warning lamp while leaving base braking intact. No manufacturer documents this code publicly; NHTSA's brake safety study and a pump patent describe the per-wheel apply valve.
Possible causes
- Inlet valve coil open or shorted high
- Harness or connector corrosion medium
- Internal hydraulic modulator fault low
Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- Normal braking retained
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0018
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.