C0014
Right Front Inlet Control
Covers the right front inlet (apply) solenoid valve of the ABS hydraulic modulator, the mirror of C0010 on the right front corner. The module closes this valve to isolate the right front brake circuit and hold wheel pressure during ABS, traction or stability control, then opens it to reapply pressure from the master cylinder or pump. It monitors the coil for opens, shorts to supply or ground and resistance outside the calibrated window. A confirmed electrical fault disables ABS and the stability functions and turns on the ABS warning lamp, with conventional foundation braking unaffected. No manufacturer documents this code publicly; NHTSA's safety study of hydraulic ABS/ESC brakes describes the hold valve used per wheel, and a pump patent shows it as a normally open apply valve.
Possible causes
- Inlet valve coil open or shorted high
- Harness or connector corrosion medium
- Internal hydraulic modulator fault low
Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- Normal braking retained
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0014
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.