C0011
Left Front Outlet Control
Covers the left front outlet (release) solenoid valve of the ABS hydraulic modulator. This valve opens to dump brake fluid from the left front caliper into the low-pressure accumulator so the module can reduce wheel pressure during an ABS or stability event, then closes to allow reapply. The control module monitors the coil for opens, shorts to power or ground and resistance outside the normal range. It is the release counterpart to the left front inlet valve C0010. A confirmed fault disables ABS, traction and stability control and lights the ABS indicator while leaving base braking functional. No manufacturer documents this code publicly; NHTSA's brake safety study names the release valve the module opens to lower wheel pressure, and a pump patent shows it as a normally closed valve beside each apply valve.
Possible causes
- Outlet valve coil open or shorted high
- Harness or connector corrosion medium
- Internal hydraulic modulator fault low
Symptoms
- ABS warning lamp on
- ABS and stability control disabled
- Normal braking retained
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0011
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.