C0004
TCS Control Channel B Valve 2
C0004 completes the set with the second traction control valve of channel B. During an intervention the module closes the isolation valve and opens the priming valve of the circuit concerned so the pump can supply pressure to a wheel that is spinning; afterwards both return to rest so the driver's pedal again acts through the master cylinder. A valve that sticks or a coil that fails can therefore leave the pump without supply or keep the circuit isolated from the pedal, which is why the module reacts at once. It sets the code for an electrical fault or an implausible pressure response, switches off traction and stability control and lights the warning lamp. Base braking stays available. No manufacturer documents this code publicly.
Possible causes
- Solenoid coil open or shorted high
- Corroded or chafed wiring to the modulator medium
- Internal hydraulic modulator fault low
Symptoms
- ABS warning lamp on
- Traction and stability control disabled
- Normal braking retained without ABS
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0004
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.