C0001
TCS Control Channel A Valve 1
C0001 concerns the first traction control valve of hydraulic channel A, usually one of the two brake circuits in the ABS/ESC modulator. To brake a spinning drive wheel without driver input, a TCS-capable modulator carries an extra isolation valve and priming valve per circuit: the normally open isolation valve closes off the master cylinder, while the normally closed priming valve opens so the pump can draw fluid and build pressure. Which of the two a maker numbers as valve 1 is not published. The module watches the coil circuit and whether pressure follows the command; a fault switches off traction and usually stability control and lights the warning lamp, while ordinary braking remains. No manufacturer documents this code publicly.
Possible causes
- Solenoid coil open or shorted high
- Corroded or chafed wiring to the modulator medium
- Internal hydraulic modulator fault low
Symptoms
- ABS warning lamp on
- Traction and stability control disabled
- Normal braking retained without ABS
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0001
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.