B0990
Body Control Module Internal Fault
For B0990 no public evidence exists, be it in J2012 lists or in carmaker or NHTSA papers. The title describes a self-detected failure inside the body control module. GM-era Saab models report this as B1000 or B101D: on the 2011 Saab 9-5 the module runs its internal test at every power-up, refuses further inputs on a fault and clears a history entry after 50 fault-free ignition cycles; a module should only be replaced if the code is current. The 9-3 BCM stores B1000 37 for an internal timeout, and its column module logs B3985 when the immobiliser code cannot be written into the BCM. TI lists open-load and short detection and fail-safe behaviour among the core BCM functions. Rule out supply and ground faults before replacing it.
Possible causes
- Poor supply voltage or ground at the module high
- Moisture or corrosion inside the module medium
- Corrupted or outdated module software medium
- Internal electronic failure of the module low
Symptoms
- Several body functions fail at once, such as lights, locks or wipers
- Car will not start if the immobiliser data cannot be read
- Code stored only as history without any noticeable effect
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for B0990
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2011/3-electrical-system/bus-and-diagnostics-communication/fault-diagnosis-diagnostic-trouble-codes/dtc-b1000
- saabwisonline.com/9-5-9650/2011/3-electrical-system/bus-and-diagnostics-communication/fault-diagnosis-diagnostic-trouble-codes/dtc-b101d
- saabwisonline.com/9-3-9440/2007/dtcs/bcm/b1000-37/
- saabwisonline.com/9-3-9440/2007/dtcs/cim/b3985-00/
- ti.com/solution/body-control-module-bcm