B0980
Ignition Switch Run/Start Position Circuit
Public sources give no meaning for B0980: J2012 extracts and OEM or NHTSA documents leave it out. The title concerns the signal by which the ignition switch reports its run and start positions. GM-era Saab vehicles use other numbers for this: the 9-3 column module sets B1440 0F when the +15 supply from the ignition switch module is open and B1368 00 when that input is shorted to battery; in both cases it blocks cranking and deactivates the steering lock. GM's 2011 Saab 9-5 energises an ignition 1 relay in run and start and stores B144A 02 for a grounded control line, giving a no-start or an engine that keeps running after the key is removed. FMVSS 114 defines the key-operated starting system and its anti-theft requirements.
Possible causes
- Worn contacts in the ignition switch high
- Open or shorted ignition feed wire medium
- Ignition relay or its control line faulty medium
- Low battery voltage causing implausible signals low
Symptoms
- Engine does not crank although the key is turned
- Ignition cannot be switched off or key cannot be removed
- Steering lock or electrical consumers behave erratically
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for B0980
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.