OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0850

Left Brake Lamp Circuit

B0850 cannot be confirmed from any open source – J2012 tables, OEM documentation and NHTSA bulletins omit it. The title covers the left stop lamp. In Saab's 9-3 (type 9440) the rear electrical centre checks it while braking under its own number B3445: below 50 mA it records an open circuit (04), and once current tops 6 A for over 6 ms a short to ground (02), shutting the output down. The third, high-level brake light is logged separately there (B3884). FMVSS 108 makes stop lamps mandatory and defines the high-mounted lamp as a steady stop warning visible through other vehicles. HELLA lists bulbs, holders, fuses and plug connections as the first checks. A missing brake light weakens the warning to following drivers and should be repaired at once. Right side: B0851.

SystemBody
Typegeneric / SAE
GroupB0
Range / number8 / 50

Possible causes

  • Left stop-lamp bulb or filament failed high
  • Corroded bulb holder in the tail lamp medium
  • Open or grounded wire to the left tail lamp medium
  • Stop-lamp output of the rear module faulty low

Symptoms

  • Left brake light stays dark when braking, warning shown
  • Weaker warning to following traffic; repair before further driving
  • Tail light on the same side may also be affected with combined bulbs

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for B0850

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication