B0810
Left Headlamp Low Beam Circuit
Whether any carmaker sets B0810 is unknown – the number shows up in no J2012 excerpt and no service literature. The title covers the left dipped-beam output. The GM-era Saab 9-3 checks it in the front electrical centre under the number B2575: with the switch at dipped beam (position 2), a draw below 0.8 A sets B2575 04 (open) and one of 7.9–30 A sets B2575 0B, which may also mean a bulb of the wrong rating. With xenon lamps the ignition has to be on for 30 s before the test can run. HELLA explains why: the xenon ballast first fires the lamp with up to 30 kV and only then regulates it to a steady 35 W. A dark left dipped beam is a road-safety defect and should be repaired before driving at night. Right side: B0811.
Possible causes
- Low-beam bulb burnt out high
- Bulb of the wrong wattage fitted medium
- Xenon ballast or igniter faulty medium
- Corroded headlamp plug or poor ground medium
- Lamp output of the lighting or body module faulty low
Symptoms
- Left dipped beam dark, lamp failure message in the display
- Reduced view of the left road edge at night; repair before driving in the dark
- Light flickers or fails only after the lamp has warmed up
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for B0810
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.