B0710
Sunroof Position Sensor Circuit
Nothing public confirms B0710: it is missing from J2012 extracts, workshop manuals and recall bulletins alike. The title refers to the position feedback of a power sunroof. Typical designs count pulses from a Hall sensor at the motor shaft: Nedap's NL1001829C2 derives panel position and speed from the pole changes, and Bosch's DE19815960A1 resets such a counter at a mechanical stop and uses it to separate sliding from tilting travel. Without valid pulses neither the anti-trap function required by FMVSS 118 nor one-touch travel can work. In the 2011 Saab 9-5 the motor unit reports an unlearned calibration as B3697 4B; the 9-3 disables express operation with B3696 0B when the motor is misfitted or the mechanism blocked. Drive circuit: B0700.
Possible causes
- End positions not relearned after battery disconnection or motor replacement high
- Hall sensor or motor electronics faulty medium
- Binding mechanism or misfitted motor medium
- Signal wire or connector at the motor damaged low
Symptoms
- One-touch opening or closing no longer works
- Roof stops short of its end position or reverses unexpectedly
- Roof can only be moved step by step until reinitialised
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for B0710
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.