OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0700

Sunroof Open/Close Circuit

No accessible J2012 list, public manufacturer manual or NHTSA bulletin contains B0700, so the code cannot be verified. Its title points to the circuit that drives a power sunroof open and shut. GM-era Saab cars report such faults under their own numbers: the 9-3 sunroof module stores B3661 0E when motor current is too high and B3664 04 for an open switch line, after which button presses are ignored; B3664 0A follows if the same switch position is seen for over 30 s. In the 2011 Saab 9-5 the module reads the switch as a resistor ladder and reports B3664 to the BCM via LIN. FMVSS 118 demands that a closing roof panel reverses before it squeezes with 100 N, which is why motor current is supervised at all. Position feedback: B0710.

SystemBody
Typegeneric / SAE
GroupB0
Range / number7 / 00

Possible causes

  • Dirty or dry guide rails raising motor current high
  • Sunroof switch or its wiring faulty medium
  • Sunroof motor or gearbox worn medium
  • Sunroof control electronics faulty low

Symptoms

  • Sunroof does not move when the button is pressed
  • Roof stops or reverses on its own while closing
  • Motor hums without the panel moving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for B0700

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication