B0292
HVAC A/C Compressor Clutch Circuit
Whether B0292 is used anywhere is unknown; no consulted J2012 list carries it and no maker documents it. Its title points to the electromagnetic clutch that couples a belt-driven compressor to its pulley, and the relay feeding the clutch coil. Usually the engine controller owns this circuit and logs P0645–P0647; on the Saab 9-3 with Trionic 8, for instance, P0646 sets when the relay output stays below 2 V for over 1 s, and the compressor may then run without stop. Patent US20040211197A1 explains that the climate unit cannot see a failed clutch unless an extra feedback path exists, and US4481784A shows the classic battery–relay–coil chain. Electric compressors without a clutch do not use such a code.
Possible causes
- Clutch coil open or shorted, often after overheating high
- A/C clutch relay failed or contacts welded medium
- Excessive clutch air gap so the plate does not pull in medium
- Clutch feed or ground wire at the compressor damaged by heat low
Symptoms
- No cooling, compressor hub does not turn with A/C on
- Compressor runs permanently even with A/C switched off
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for B0292
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.