OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0283

Rear Defogger Relay Control Circuit

B0283 is not in any publicly available J2012 list; it is documented by Saab/GM, where it means the heated rear window relay, not a blower. In the Saab 9-3 (2003–2012) the rear electrical centre sets B0283 01 when the relay output exceeds 6 V with heating on, and B0283 06 when it stays below 6 V (open or grounded line). The GM-built Saab 9-5 and 9-4X of 2011 run the test in the climate module at 9–16 V: 02 means a grounded relay control line and the grid heats nonstop, 05 means open or short to voltage and the grid stays cold; a history code clears after 50 ignition cycles. As US4673797A shows, such relays are usually timed and drop out after a set period. Front blower faults belong to B0181/B0186; the heating grid itself is B0950.

SystemBody
Typegeneric / SAE
GroupB0
Range / number2 / 83

Possible causes

  • Rear window heater relay with open coil or welded contacts high
  • Relay control wire open, grounded or shorted to battery voltage medium
  • Poor ground or corroded socket at the relay medium
  • Output stage of the climate or electrical centre module faulty low

Symptoms

  • Heated rear window does not work when switched on
  • Rear window heats continuously and cannot be switched off
  • Battery drained if the grid keeps heating

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for B0283

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication