B0239
License Plate Lamp Circuit
B0239 cannot be traced in any J2012 source or factory document, so its use stays unproven; the same title belongs to B0860. The licence plate lamp lights the rear registration plate and is usually wired with the tail lamps. FMVSS 108 asks that it illuminate the plate without obstruction by body parts. HELLA quotes the European rule that the plate must be readable from 25 m, with no part of it below 2.5 cd/m². Body modules today monitor lighting outputs, and HELLA's Golf 6 example shows the other side of that: after fitting LED rear lamps the module must be recoded, or it reports lamp faults. A circuit fault here leaves the plate dark, which can lead to a police stop.
Possible causes
- Plate lamp bulb or LED unit failed, often from water inside the housing high
- Wire broken in the flexible tube between body and tailgate or boot lid medium
- Retrofitted LED lamp not matched by the body module coding low
Symptoms
- Rear number plate is not lit with the lights on
- Bulb warning in the cluster, where the car monitors this lamp
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for B0239
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.