B0235
Brake Lamp Circuit
No publicly available J2012 list contains B0235, nor does any carmaker describe it, which leaves it unverified; side-specific brake lamp codes are B0850 and B0851. Stop lamps send a steady red signal rearward while the driver brakes, and FMVSS 108 also demands a third stop lamp mounted high. The brake light switch at the pedal triggers them, directly or via a body module. HELLA describes a Golf V in which one 21 W bulb works as tail lamp on a PWM signal of about 5.7 V and as stop lamp at a full 13.5 V, so one wiring fault can hit both jobs. On a Mitsubishi Grandis, moisture inside the brake light switch even lit the traction and stability warning lamps. A dark brake lamp raises the risk of being hit from behind.
Possible causes
- Stop lamp bulb or LED unit failed high
- Brake light switch misadjusted, worn or wet inside medium
- Blown fuse or broken wire, often in the tailgate or boot lid harness medium
- Corroded lamp holder or plug in the rear light cluster low
Symptoms
- One or more brake lamps stay dark when the pedal is pressed
- Bulb warning shown, sometimes together with traction or stability warning lamps
- Safety note: following traffic gets no braking signal; repair before further driving
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for B0235
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.