OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0226

Headlamp Auto-Leveling Front Sensor

The publicly available J2012 lists have no B0226, and no maker documents it for headlamp levelling. Saab uses the number in its 9-3 climate control: B0226 01 is a short to B+ in the recirculation motor circuit, possibly causing stale air or misted windows. Automatic levelling, as HELLA explains, keeps the beam cut-off steady as the load changes. A control unit compares front and rear axle sensors with stored values and drives small motors in the headlamps; dynamic systems, found on almost all xenon cars, also correct for braking and acceleration. Compact cars often omit the front sensor. Each axle sensor is an angle sensor whose lever is clipped to a suspension arm; older ones use a potentiometer, newer ones inductive measurement. With the front sensor failed, the beam stays where it was.

SystemBody
Typegeneric / SAE
GroupB0
Range / number2 / 26

Possible causes

  • Lever or coupling rod of the front axle sensor bent, broken or detached high
  • Connector or wire at the sensor corroded or damaged by road splash medium
  • Sensor worn out internally or not calibrated after replacement or suspension work medium

Symptoms

  • Headlamp levelling warning shown and beam height no longer adjusts
  • Oncoming drivers flash because the beam is set too high under load

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for B0226

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication