B0190
Front Wiper Park Switch Circuit
No known public source lists B0190, neither a J2012 table nor a carmaker document. The part named in the title is common: a cam on the wiper gear opens or closes contacts, so the control knows when the blades are at rest and can keep the motor running until they get there. Controllers also use this signal for protection. In US5694011A a timer set longer than one wipe cycle cuts the motor if the park signal stops changing, which catches blades frozen to the glass; US4320329A treats a missing park position after a cycle as a blocked motor and lengthens the pause. A patent by FCA, US8598828B2, filters the contact signal so noise is not taken for a state change. With a faulty circuit the blades may stop anywhere, keep sweeping after switch-off, or intermittent mode misbehaves.
Possible causes
- Park contacts in the wiper motor gear housing worn, dirty or corroded by water high
- Park signal wire or connector at the wiper motor open or shorted medium
- Fuse or relay in the park supply circuit failed low
Symptoms
- Wipers stop in the field of view instead of at the bottom of the screen
- Wipers keep running after being switched off or intermittent mode fails
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for B0190
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.