OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Body generic / SAE

B0188

Rear Wiper Motor Circuit

B0188 cannot be traced: it appears in no publicly available J2012 list and in no public carmaker material. The rear wiper meaning repeats B0910, titled Wiper Motor Rear Circuit. Bosch describes the part: unlike the front system, the rear wiper has a single arm driven straight off the motor, with sweep angles from 88 to 177 degrees and wiped radii of 250 to 500 mm. Because motor and harness sit in the tailgate, the circuit must cope with hinge flexing and moisture. Audi traced dead or intermittent rear wipers on the 2010–2015 Q5 to corrosion at splice B538 in the motor control circuit; the voltage drop pushed the control signal out of range, and the splice was repaired. With the circuit open or shorted, the rear window stays unwiped.

SystemBody
Typegeneric / SAE
GroupB0
Range / number1 / 88

Possible causes

  • Wires broken in the rubber boot between body and tailgate after years of opening high
  • Corroded splice or connector in the rear wiper control circuit causing a voltage drop medium
  • Rear wiper motor seized, for example from a corroded spindle, or internally shorted medium

Symptoms

  • Rear wiper does not move or works only now and then
  • Rear wiper stops away from its rest position

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for B0188

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication