B0170
HVAC Mode Door Position Sensor
Searching the available J2012 lists and public manufacturer material turned up no entry for B0170 with this title. Unlike B0150, which concerns how the mode door moves, this code points at the sensor that reports its position. In most electronic climate actuators that sensor is a potentiometer on the gear train; a Motor magazine article puts its signal at about 0 to 5 V and notes that simple recirculation actuators often have none. Hyundai's patent US9960727B2 drives intake, temperature, mode and defog door motors until the feedback voltage matches the target and watches the motor current for stalls. A lost or noisy position signal leaves the module unsure where the door is, so it may stop driving it.
Possible causes
- Worn or dirty potentiometer track inside the mode actuator high
- Feedback signal, 5 V supply or reference wire open or shorted medium
- Bent or pushed-back pin in the actuator connector low
Symptoms
- Air distribution stays fixed in one position
- Actuator runs repeatedly or ticks after switching on
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for B0170
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.